Dust cap for Fanatec wheel bases CSL DD CSW etc
Description
Simple dust cap to fit fanatec steering shaft. Should be a fairly loose fit once printed. (If you need it to be tighter, apply a small trip or two of tape inside the cap for a snug friction fit) PLA PETG etc no problem, print with logo on bed - nice squished first layer will give a good appearance especially with textured beds. Easy job, You can do a filament change after 0.4mm (two layers at 0.2mm), then again after another two or three layers to achieve the two tone logo) if you wish. I designed this in September 2020, inspired by a similar cap design, but it had no logo (or location strip I think) so I drew this up to protect my Fanatec CSW2.5. There are now many other peoples designs floating around, have a look and see which you prefer.
Statistics
Likes
2
Downloads
0