Clip On Spacers for 1/2 Inch Hex Shaft
Description
INSTRUCTIONS: This is a clip on spacer used for 1/2 inch hex shaft. To clip onto a shaft slide the inside spacer on the shaft and clip on the outside spacer. To remove it take a flat head screwdriver and put it into the groove then twist. TIPS: use a wider flathead screwdriver for best results when removing A screenshot of the dimensions are included if you want to make it custom length The files are given in millimeters so if the part is too big or too small check the dimension settings in your slicer A wall thickness of 1.2mm or less is recomended for the best results It is not recomended to print it longer than 2 to 2.5 inches because it can become harder to seperate If you found this part helpful please leave a donation. All money will go to the team to support them in building and designing their next robot. Thank you
Statistics
Likes
0
Downloads
0