Smartphone stand #4 (Z-shaped)
Description
I made a V-shaped smartphone stand before, but there was a slight problem, so I made a new Z-shaped one. Since I added a lock mechanism, the stand does not open accidentally when you carry it as a key chain. https://youtu.be/1oAdw-k_mTo [size] height:21.5mm, thickness:9mm, length:75mm [screws to use] M3 CAP 18mm x2 It is recommended to use glue to prevent the screws from loosening. No nuts needed. [print conditions] -printing type: FDM -printer: Original Prusa i3 MKS -filament: PLA, PETG -support: no -brim: no -raft: doesn't matter -print directions: Please refer to the photo [revisions] 2022/03/25 I made the length a little longer. 65mm-->75mm. And also I narrowed the slot a little. Sorry, this has not been print tested. The photos are still the old version.
Statistics
Likes
8
Downloads
0