Delta Case - Reviung41
Description
The Delta Case is my take on a 3D printed gasket-ish mount case for the Reviung41 (designed by gtips) based on the original case files on github. Information about the keyboard, pcb, and plate files can be found here: https://github.com/gtips/reviung/tree/master/reviung41 Note: While the case is 3D printed, the top plate is not. This design requires the standard top plate per the files on github, as well as the standard spec M2 standoffs. Case height offset can be adjusted with different length standoffs or by scaling the thickness of the gaskets. Different length screws may be required. I am marking this project as WIP because I may revisit to design a different top plate and fill in any gaps. I like a uniform top, this was made to accommodate my existing plate. Delta Case BOM: - 1x Case Full (or 1x each Case Right and Case Left) - 2x Gasket Outer - 1x Gasket Inner - 1x Delta Badge - 1x MCU Cover (with or without encoder hole) - 1x Top Plate Holes Cover (not required, preference item) - 2x 7ish Deg Foot (gives roughly a 7 degree typing angle) - 5x M2x6 screws (for case) - 2x M2x12 screws (for case through feet) - 3x M2x10 screws (for mcu cover) - 4x Bumpons for feet (I use 3M electronics bumpons) - 7x M2 standoffs (standard from reviung41 github build) CAN'T PRINT TPU? DON'T WORRY ABOUT IT! If you print the gaskets in standard PLA, assembly is the same and the case will act as a normal tray mount. USB CONNECTOR NOTE: Due to the geometry and design of the Reviung41 PCB, there is a very small amount of room for the connector. This case only works with lower profile usb connectors. I have not yet tried a 90 degree cable because I don't have one, but I'd imagine that would do the trick.
Statistics
Likes
2
Downloads
0