Quest 2 Elite strap quick fix
Description
This fix prints a quick bracket to support the damaged area of the Oculus 2 elite strap. Install instruction: - Print - Snap the "lid" of the "bracket" - Place "bracket" around strap. - Close the lid (make sure it is a tight fit). NB! This is a tight fit! But depending on the shrinkage and printer setup it might not fit because of the small tolerances. A tip from me is to print it out 0.5cm for a test run to see if it fits your device. Then print the entire 3.5cm when it fits. Add tape or something underneath to tighten it up if needed.
Statistics
Likes
5
Downloads
0