Geekvape S100 Stand, Cap, and Tank cover TPU
Description
Just a stand to keep your Geekvape S100 from falling over on your desk, but also fits in a car cup holder. I made mine from TPU. If PLA makes too tight a fit, you can try to scale it up in your slicer by a few % Also added a Tank Cap combo cover. also TPU for the Zeus tank and a Tank cover and a Cap separate. no supports needed .2mm Layer Hight I use Ziro TPU and keep the same slicer settings as for PLA and it prints very well. no need to disable retraction or run slower then 40 mm per sec.
Statistics
Likes
0
Downloads
0