B1 SE Plus Hotbed Glass Hold Down Clips
Description
This is for the BIQU B1 SE Plus hotbed. Stock it comes with two clips (front and back). I wanted to upgrade the clips and move them to the corners. I designed this so I could remove the factory clips. Note that you can only use three of these as the back left corner has a wire in the place of where this would go. I have added side clip incase you want to clip onto the side. Uses same screw and nut, just is straight so it can clip on the straight edge. Four parts to this: 1. The corner clip. I printed this upside down and used a tree support. 2. The screw. This goes around the the hot bed mount and through the corner clip. 3. The nut. This is to tighten the clip to the screw holding everything in place. 4. The Side Clip. This will clamp onto the straight edge. (I have not printed this yet, plan to soon as the front left corner clip on mine got hit, so I have to move it) I printed these in PETG. Please print and use at your own risk. Feel free to give me feedback.
Statistics
Likes
1
Downloads
0