TinyG Enclosure for Shapeoko 2
Description
An Enclosure For The Tinyg Motion Controller From Synthetos. Mounts To A Shapeoko 2 Endplate. Includes Cutouts To Run Wires To All Motor Connectors, Limit Switch Connectors, Etc. Cutout On The Front Face Is For Mounting A Fan. It Was Designed To Fit The 24V Fan From Inventables. Vent Holes On The Back Are For Exhausting The Heat Sinks On The Bottom Of The Board. I Believe The Hardware Were 4-40 And M2 Screws. You May Have To Drill Some Of The Holes Out To Get Them To Fit. I Don'T Have Screws Installed In The Pictures, But I Do Now, And Have Been Using The Enclosure With No Problems.
Statistics
Likes
59
Downloads
0