Kitchenaid lift stand mixer feet
Description
This model is sized to account for the shrinkage of a 100% solid part in PLA. The screw hole and all dimensions are adjusted to use the stock screw, or an M3 screw and t-nut. Place the nut or t-nut on some cellotape and line it up from behind with the hole, then tape it to the metal flange. The standard screw is tapered, so do not over-tighten to the screw using the stock screws. For TPU, you might consider adding a metal washer the diameter of the foot as the base, as the metal flange is rectangular and TPU will deform over time. You can print PLA, pause, then print TPU as the balance of the foot if you know how to do this. I have felt feet on the bottom to allow me to move the mixer easily across my workspace. You should substitute a non slip surface to prevent movement of the mixer.
Statistics
Likes
0
Downloads
0