Wheelchair cup holder
Description
This was printed with CR6-SE. i would go full infill because i didn't make it dense i cut out diamonds to give it a cool look while still saving on filament. this snaps on a wheelchair should fit most. i made it where it wasn't to big but it will fit your normal drinks poweraid, sprite, coke bottles and etc. if for some reason you need it bigger for say a big waterbottle or something leave a comment and i will make it for you. i really hope this helps a lot of people have a little bit of a bit life. Thanks all for looking at it. NO SUPPORTS NEEDED.
Statistics
Likes
0
Downloads
0