Printrbot Simple Metal GT2 Belt Clip
Description
Simple Belt Clip Noticed That The Default Cable Tie Method, As Per Instructions Leads To Slippage In Belt Tension Over Time... Top Tip... The Screw That Holds The Belt In The Hole At The Extruder End Of The Y Axis In The Instructions (Step 24). Is Not Long Enough (M3 10Mm), Put A Longer One In To Avoid The Belt Pulling It At And Angle. Then When Fitting The Y Arm Just Use A Shorter Screw On The Opposite Side Or Just Miss It Out... Reference: Http://Help.Printrbot.Com/Guide/Printrbot+Metal+Simple+%28Model+1403%29+Rev+F+Printrboard/151 Warning: You Must Secure The Clip It With A Cable Tie... Note: Please Make Sure You Fit Them With The Same Orientation As Shown On Both Ends Of The Belt, (Base Facing Away From Stepper Motors), Otherwise You Will Have Interference Issues...
Statistics
Likes
88
Downloads
0