PC Master Race Guy (PCMR)
Description
Designed the PC-Master-Race-Guy (PCMR-Guy) from various images I found online. The model with "Filament arms" can be printed at 100 % scale to use a 1.75 mm filament for the arms. This was the initial idea because the PCMR-Guy is displayed without arms most of the time. The total model size at a 100 % scale is about 10.5 cm (or roughly 4" in retarded units). However, for those of you who would like to increase the size of the final figure, I tried to model muscular arms with massive "additional" shoulders. The model was printed on a Prusa MK3S with 0.1 mm layer height. PLA was used with temperature settings at 200 °C using brim and support. To lower the center of gravity, I used 40-60 % infill for the lower parts like the "Boots" and the "Body". For the "Hair" I used 8 % infill so the figure won't tilt over easily. The "Boots" have been modified so that tiny magnets (diameter 6mm, height 3 mm) will fit in. Now the PCMR-Guy will stand steady inside my case. Feel free to improve the design and print parameters
Statistics
Likes
0
Downloads
0