Tyro129 - Gps and Antenna Holder
Description
Print it in TPU Only! This is my holder, the geometry follow the frame. Gps is locked in by two teeth, so you don't need to screew or tie anything. Antenna is tilted at 35° degrees. There are two version, one is without space for gps connector, so you need to solder the cable directly on gps pin. Designed for eachine tyro 7 inch (129). Designed to print without support. You need only two screw that are the dimension of motor screw, minimum lenght is 6mm (2mm print part and 2 of carbon). Thank you for download, and leave me advice to improve the design in the comment :)
Statistics
Likes
0
Downloads
0