NSK BullsEye Fanduct for FLSun SR
Description
This model is designed to work better with high flow blowers like 5015 It comes with the Quick install plate. just losen the screws, slide the previous fanducts out then the new ones in, tighten, that's done ! Before printing, measure the distance between the bottom of the effector plate and the tip of your nozzle and ajust Z scale in your slicer if needed (1mm to 2mm clearance above the tip of the nozzle is usually enough) Printing tip: Print the 2 fanducts at the same time like shown on the picture, it will help the material cool better between two layers. You should obtain a better precission wih a a 0.12 layer height
Statistics
Likes
2
Downloads
0