NSK Miniflow fanducts for FLSUN SR
Description
Those models are suitable for the stock 4010 blowers but can be a bit tight for 5015 They come with the Quick install plate. just losen the screws, slide the previous fanducts out then the new ones in, tighten, that's done ! Before printing, just measure the distance between the bottom of the effector plate and the tip of your nozzle and ajust Z scale in your slicer if you need a different size (1mm to 2mm clearance above the nozzle is usually enough) Printing tip: Print the 2 fanducts at the same time like shown on the picture, it will help the material cool better between two layers. You should obtain a better precission wih a a 0.12 layer height
Statistics
Likes
0
Downloads
0