Artillery SWX1 Spool Mount
Description
This setup allows you to mount a filament spool on a table surface next to your Artillery SWX1, allowing the use of larger spools with less Z wobble. It uses the stock spool holder, which slides into the stand pieces, and the stock T-nuts and bolts for the Top Guide to mount to. Extra Materials Needed: A PTFE tube 2 x (M3 x 12mm Bolt) 2 x M3 Nut You will also need to print two T-Nut drop-in pieces found here https://www.thingiverse.com/thing:3050607 *When mounting the top guide, loosely thread the bolts in, then apply pressure to the part so that it makes good contact with the top bar, then tighten the bolts. There should be no gap between the parts. If there is a gap, the top guide will dip down every time the extruded pulls, and then bounce up on retraction, increasing wear and tear on the part. *The side guide can be mounted on either side of the printer, but should have the longer side upward, for the PTFE tube to seat into.
Statistics
Likes
0
Downloads
0