Heewing T1 Ranger DJI Airunit FPV Mount
Description
This mount will allow you to mount a DJI Airunit above a flight controller in the Ranger (you will need to use a WSE sized controller) i am using the 765-wse. it hinges on the spar and allows for you to close the canopy just fine. Note that there is not enough space to use the Pins and then a connector on the FC so you will need to direct solder to the FC for the servo connections etc. you will need a 40mm fan I am using a 5v raspberry pi 40mm fan and powering it from the 5v BEC. You do not need supports for the arms only the main body (i printed that on its side) I personally would not use PLA due to the heat of the air unit PETG/Firm TPU would be best. However you might get away with PLA+
Statistics
Likes
0
Downloads
0