Realacc X210 parts stackable 30.5mm / XT60 hold / RX / TBS antenna hold, Buzzer hold
Description
Some useful stackable parts for the beloved X210 frame. I printed the XT60 holder, the RX antenna holder and the Buzzer holder from flexible material. Don't know if the XT60 would fit in PLA or similar ;-) The TBS antenna holder can be printed in whatever. Afterwards bend it over the bending mark (45°) and glue it together (in the bending gap) with a proper glue. The XT60 male plug is of course also secured with some CA in the flexible holder. If you print the RX antenna holder properly without support you can insert the ends of the RX antennas in the holes and secure it a little bit (glue, chewing gum, liquid rubber, hot glue...whatever you like) have some fun..
Statistics
Likes
0
Downloads
0