Sig Sauer LDC 2, P226, X-Five - Baseplate plus 0/1/2
Description
Custom Sig Sauer LDC 2 baseplate plus 0/1/2. **If you like my designs and don't mind I would be happy about a beer. (Tip Designer)** Plus 2 v3: - 16mm height - 19 rounds fit better Plus 1 v1: - No changes since release Plus 0 v8: - No changes since release **Additional notes** - Use spray paint to get your favorite color if not possible with your filament - Tested with LDC 2 - Untestet but should also fit LDC, P226 and X-Five **Additional requirements** * None **Printing - Baseplate plus 2** - Layer height: 0.1 mm - Support: yes (**tree preferred**) - Infill: 15 % - Brim: yes - Material: PETG (preferred) **Printing - Baseplate plus 1** - Layer height: 0.1 mm - Support: yes (**tree preferred**) - Infill: 15 % - Brim: yes - Material: PETG (preferred) **Printing - Baseplate plus 0** - Layer height: 0.1 mm - Support: yes (**default - only touching build plate!**) - Infill: 15 % - Brim: yes - Material: PETG (preferred) **Assembly** After printing remove the support material and make sure the little hole is clean/empty. Then put your magazine together.
Statistics
Likes
0
Downloads
0