CR10S Pro VORON Stealthburner Adapter
Description
An adapter for installing VORON Stealthburner toolhead on your Creality CR10S-Pro (if V2 shares the same X-carriage plate, then it works for V2 as well). Just use this adapter to connect stock X-carriage plate and the SB assembly. The adapter is designed for using LJ12A3-4-Z/BX as ABL (or any other M12 cylinder sensor). Some M3 screws will be used. If you are assembling a VORON SB toolhead then you should have plenty of spares for them. After installation, you need to set probe offset X29, using G-code as following: <blockquote> <p>M851 X29</p> <p>M500</p> </blockquote> Offset your nozzle Y-28 by adding a line in printer's starting G-code right after G28 and G29 lines: <blockquote> <p>G28 X0 Y0 ;Home</p> <p>G29 ;Auto bed Level</p> <p>G92 Y-29 E0 ;Reset Extruder</p> </blockquote> Of course you can also do both offsets in the firmware configuration. Print guide: Lay down to the print bed, no support needed
Statistics
Likes
1
Downloads
0