Iphone 13 Pro Max MagSafe Vertical Stand w/12mm case
Description
Remixed the original MagSafe Vertical stand to accommodate the case my phone is in while sitting in the stand. I just extended the bottom portion the phone sits in to fit the phone case which I measured to be 12mm (the former was 9.84mm). I use a Rhinoshield SolidSuit case on my iPhone 13 Pro Max so make sure to measure your case if you plan on using this stand. Same print settings as the original: Print Settings Printer: TinyboyE8 Rafts: No Supports: Yes Infill: 30% Fast Honey Comb Filament brand: JAYO Filament material: PLA+
Statistics
Likes
0
Downloads
0