Sig Sauer LDC 2, X-Five - Magwell
Description
Custom Sig Sauer LDC 2 magwell. **If you like my designs and don't mind I would be happy about a beer. (Tip Designer)** v16: - No changes since release **Additional notes** - Use spray paint to get your favorite color if not possible with your filament - Tested with LDC 2 - Untestet but should also fit LDC and X-Five **Additional requirements** * M3*12 screw to lock the magwell in place **Printing** - Layer height: 0.1-0.2 mm - Support: no (not needed!) - Infill: 100% - Brim: yes - Material: PETG (preferred) **Assembly** After printing remove the brim material and make sure the little hole is clean/empty. Then put it into the bottom of your handgun and use the screw to lock it.
Statistics
Likes
0
Downloads
0