New Pocket Wallet - Maybe the perfect solution
Description
## My Desgin for a Pocket Wallet with coin holder *You need: * - a ~84 long mm with diameter of 1,5 to 2 mm shaft for the hinge (I guess you can use your Printing Filament) - a 20 mm (2 cm) wide and 160 mm (16 cm) long elastic cord - a bit of an sew skill to sew the cord - the 3D-printed parts - IF NEEDED: The sewing plan printed on paper (cut it out and make shure it is the right lenght) ## Instructions 1. Get the Matirials Listed above 1. _I asume the Matirials are already the right lenght_ 2. Sew the Elastic Cord how in the Plan showed 3. Now you can flip it inside out 4. put the first printed part on the seccond part and put the shaft inside the hinge 5. heat some filament above the hinge hole on the first side so that it fills the hole 6. turn it and repeat 7. make shure that it opens / Close ## You´re done
Statistics
Likes
0
Downloads
0