Mavic Air/Spark/Pro Phone holder (iPhone 11 w/OtterBox)
Description
This is a remix of a very good design but it wouldn't fit my iPhone 11 with an Otterbox case. I made the phone tongs wider and deeper, and changed the screw to have a hex head that is long enough to easily screw in. I printed the bracket and tong at 30% infill and 40mm/s speed because there is some overhangs in the threads. You also have to enabled supports. The screw was printed at 60% infill for strength, but you could probably do it with less.
Statistics
Likes
0
Downloads
0