Photon Mono X Cover Riser / No Drill Cable Hole for PTC Heater
Description
Anycubic Photon MonoX 4K Lip Riser, it will probably fit the 6k version as well, to my knowledge the body is the same. An idea for a short easy to print riser for the Mono X if you dont want to drill holes for cables in your cover. Inspired by: https://www.thingiverse.com/thing:3442165 The hole is a 8x8(7)mm square, should be big enough for most power cables, I used a bit of silicone to glue it to my mono X base and ensure its as airtight as possible and easy to remove later on if needed. This is a quite tight fit, you may need to sand the ends of the pieces just slightly to make the cover fit nicely, also reccomended for gluing the frame together. If the hole is too small for your cable I suggest increasing the size in Z dimension or just drill a new one.
Statistics
Likes
2
Downloads
0