Dremel 3D20 Build Plate
Description
The square cutout with holes is so you can put this on a level surface and fill the area with self-leveling resin. I put mine through a planar to get the surface as flat as possible, taking the smallest cuts I could for a nice clean surface. Just be sure to tape the top so once the resin starts to set, you can take it off without too much fuss. Also included is a non-resin version if you wish to try that. I decided to try this because Dremel dropped the 3D20 support and you cannot find the level plates any longer, and mine has warped over time. Might even be able to CNC a piece of glass with this model. It is accurate to about half a MM.
Statistics
Likes
0
Downloads
0