Hikoki C10RJWAZ Table Saw Vacuum Adapter Festool/Nilfisk/Makita OD44.5 to 42mm
Description
I wanted to connect my Wet/Dry Vacuum Cleaner from Makita (which seems to be made by Nilfisk) with a Festool Adapter Set(Dust extraction set CS 70 AB - 488292) to the Hikoki C10RJWAZ Table Saw. So I made an Adapter for a Hikoki C10RJWAZ Table Saw to get the 36mm Vacuum Adapter from Festool/Nilfisk/Makita connected. I don't know why it's called 36mm because the inner diameter seems to be about 38...The outer diameter on the 36mm Festool Vacuum Adapter is about 44.5 mm and the outer diameter on the side from the Hikoki Table Saw is about 42 mm. I added a little extension for a ribbon to tie it. With this Adapter I was able to connect the saw to my vacuumer without lowering the diameter. I have tested the physical connection which seems to be fine. Most Filaments should work fine. It has to be printed with the smaller side(where the ribbon extension is) to the bottom! If you don't like the extension for the ribbon you can simply cut it off after printing.
Statistics
Likes
0
Downloads
0