55mm_belt_mag_holder(support)
Description
This is a remix. The original said that it did not require support if your printer had adequate cooling. It appears that mine did not. I got one to print well enough to work, but the area where the magazine locks into place is not the prettiest. I wanted to avoid using supports because it was going to waste a ton of pva plastic to try and prevent the print from drooping. This is my attempt to get a better print by securing the only area that really needs supports. I'm hoping that they should be pretty easier to clip off with pliers afterwords. I'll post results after its done.
Statistics
Likes
0
Downloads
0