350z universal phone holder
Description
This is a new version of a phone stand/holder for the navigation box of a Nissan 350z. This one is designed to fit phones with overall thicknesses less than half an inch (12.7 mm). It's designed to be printed at any settings you like with no supports. I'd stick above 10% infill for longevity and heft. For the previous version I used PLA+ filament, which did fine for the winter months. However after several heating/cooling cycles in the summer, the internal strains were allowed to relax and caused the model to curl at the base or "potato chip". So, be sure to use PETG or ABS/ASA filament if you want lasting results. Reach out to me if you'd like me to send you one and I'll give you a quote. Also, consider sending a few bucks my way if you are satisfied with how yours turns out. But most importantly, happy printing!
Statistics
Likes
0
Downloads
0