90 degree elbow for 65mm Agg Pipe Drainage
Description
This is a 90 degree elbow for connecting 65 mm slotted agg drainage pipe. It is in three parts (2 x45deg sections plus the sleeve joiner) to make it easier to print and is intended to be glued or plastic welded (3d filament Pen) to get the 90degree joint. There are small internal nubs on the ends to engage the ribs on the agg pipe. I would recommend using PETG for the print and I had to use a raft to stop the print separating from the plate. Print time was 5:50 and consumed 68g of PETG
Statistics
Likes
0
Downloads
0