Gravitrax tiles with bridges variations
Description
My attempt to bridges on long curves. Of course you'll need some speed to overcome the steep raise, so dont print unless you know where to use :-) My tiles have the bottom hex connector incorporated in the bottom of the print. Ensure your first layer is precise (no overextrusion there), print, pop the hex connector out, turn it 30°, clip it in. Add some glue if you feel it needs it. Those 4 tiles are a "special" addition to the 65 tiles here: https://www.thingiverse.com/thing:4538769 (**along with all print instructions and further advices**) Also, if you are into some "even less ordinary" ones, check the "infinity" variations here: https://www.thingiverse.com/thing:5367250
Statistics
Likes
0
Downloads
0