Nerf N-Strike Elite Double Magazine Connector
Description
Saw a few ideas online about a double mag setup and also the Modulus dual clip looked really cool so I designed this up so people can make a few if they want. Parts: 8 x M3 heat insert 8 x M3x10 screws It could also be changed in the attached .step files to accept any screw diameter without the heat inserts, but I worry about repeat use and then stripping of the threads in the plastic. The fit is not tight and requires the screws to hold the clips. There is only the slightest marking on the clips. The screws only touch the part and add some pressure. No support is required to make these parts. They are designed for 3D printing.
Statistics
Likes
0
Downloads
0