"Cut indicator" for 40W Laser Cutter
Description
Fixture To Hold A Red Laser Diode At The Correct Angle To Show Where The Laser Will Cut. You May Need To Pass A 6Mm Drill-Bit Through The Angled Hole If It'S Too Tight. Also, Tap The Hole In The Side, 4Mm, This Is For A Set Screw.. I Found It Necessary To Glue The Threads Of The Lens On The Diode To Make It Steady The Holes For The Screws In The Top Are Designed For 3Mm Taper-Head Screws. ..
Statistics
Likes
38
Downloads
0