Ender 5 plus filament guide
Description
Filament guide for my Ender 5 plus, have my spool mounted on the side but the filament was making a 45 degree angle into the filament sensor. Not good. Made this to make sure filament enters at a more perpendicular angle. Mounts on stock Ender 5 plus spool holder arm, single M6 hole (5mm), tap it yourself. Or model a hex in for a M5 nut. I recommend buying a tap. Two pins on the other slots, unnecessary actually. Plane cut those off to save yourself some time, filament and 2mm off the z axis. The spool holder side flanges support the guide arm sufficiently.
Statistics
Likes
0
Downloads
0