Turret
Description
Please take note i am not a experienced documenter! This is just one of my fun projects wich wasnt intented to be shared However! im surely going to give this thing a finnishing tuch (but just later) And so whenever i am going to make one!i will actually shink about the best fastest and easyest building steps! i will organize on documentation + building steps (i am considering video instructions!) Anyways here we go!, make sure you have printed all parts! Step 1 - Install Servo X (wirelength : Step 2 - Install Servo Y (wirelength : Step 3 - Install the lasers Step 4 - Solder the indicator led (weirelength: 2x 80mm, 1x 60mm) (*Missing) Step 5 - Solder the effect led (3x wirelength : 1x wirelength+220ohm resistor) Step 6 - Install the effect led (let the led pcb stick out +- 10mm out of the gun!) Step 7 - Solder the lasers Step 8 - Solder the lasers to the remaining wire from step 5 Step 10 - Install effect led and lasers (*Missing) Step 11 - Install the indicator led Step 12 - Solder the signal wires of the base Step 13 - Mount the gun to the holder and guide the wires trough its path Step 14 - Solder the extension wire for Servo Y (3x wirelength, 1x wirelength) Step 15 - Place the bearing and mount to base Step 16 - Solder the laser and Servo Y signal wires Step 17 - Comebine all 5v and gnd wires Step 18 - Solder the 5v and gnd wires to the wemos (i used 330uf capacitor) Step 19 - put the thing together, and upload a simple sketch to it, using D1 as AxisX D2 as AxisY, D3 as LedPin and D4 as FirePin
Statistics
Likes
0
Downloads
0