EDC Container Box Capsule + O Ring
Description
After downloading and using a nice EDC Container I instantly wanted to create my own version :) I designed it to be waterproof, slim profile and it should be able to contain a 18650 battery. Also it should be able to secure it with a lanyard/ rope, be very stable and have a smooth inner tube. I dunked them in water and none of these containers leaked air. But of course that is not enough for me :) So I put them into my vacuum chamber and tested the container to their limits! I printed different versions with PLA, PETG, TPU, PA-CF 2 of my versions need an O Ring about 17 mm x 2,5 mm EDC Out Ring ---> Is the only Container which did not load any water and is even air tight. EDC In Ring ---> Didn´t load water with half vacuum test but took a little water with full vacuum. EDC No Ring ---> Did load water with half vacuum. Original ----> Same as No Ring but this version takes Air/ Water even through the roughened areas. So the tested Order of Sealing quality is EDC Out > EDC In > EDC No > Original I hope you like my Design of an EDC Container. I´m open to suggestions for improvement and would love to hear some feedback :) Have fun and keep printin!
Statistics
Likes
0
Downloads
0