GA Trim Wheel Cover for Honeycomb Bravo
Description
This is a remix of eclair4151's trim wheel cover. I wanted one that didn't have any 90 degree overhangs on the knobby bits, and had a nice rounded feel on both sides. I also added a slight radius on the inside and a bit of a lip that helps hold it in place. It pops right on and stays put. It should be printed with the larger flat surface on the print bed, no supports needed. I'd recommend TPU filament, no idea if you'll be able to get this on with PLA or other rigid filaments.
Statistics
Likes
0
Downloads
0