Feinwerkbau - trigger replacement
Description
Custom Feinwerkbau trigger replacement. Tested with: - Feinwerkbau 601 **If you like my designs and don't mind I would be happy about a beer. (Tip Designer)** v1: - 4.5mm thread v2: - 5.0mm thread v3: - 5.5mm thread **Additional requirements** * None **Printing** - Layer height: 0.1 mm - Support: no (not needed!) - Infill: 100% - Brim: yes - Material: PETG (preferred) **Assembly** After printing remove the brim material and make sure the little hole is clean/empty.
Statistics
Likes
0
Downloads
0