Amiga A1000 Backplate for RGB2HDMI (3 parts for 20cm printers)
Description
This is my remix of the already available Amiga 1000 backplate from Thingiverse. Some dimensions weren't correct (around 2mm wrong in some directions) and - the main reason - it wasn't printable on my Ender 3 Pro. I placed the HDMI output above the RGB port, directly behind the RGB2HDMI Raspberry solution inside the Amiga. Also I have placed a 7 mm hole for the Switch most RGB2HDMI solutions use to set some preferences on the Raspberry Zero. The right part was corrected by a few millimetres to fit the A1000's first 3 ports starting with the keyboard. The middle part was completely redone - so new holes and an additional HDMI port. The right part with the fan grill only has a fixed monitor port, now perfectly on the plug. I only put the parts into the guide rail at the back of the Amiga 1000 housing. Usually there's no connection (e.g. with glue) necessary. But you can try if you want :)
Statistics
Likes
0
Downloads
0