Сlamp cupholder for 25mm vertical rod
Description
Cupholder made as a clamp for 25mm vertical rod. It can be used with standard 300 ml paper coffee cup. The inner diameter of the cupholder is 77 mm. I've printed it with 0.3 mm layer. As for infill, I've printed it with 100%, but I think that 0% would be quite good too. I use this holder in the EMS car, where we have metallic vertical rods inside. Подстаканник на клипсе. клипса под вертикальную трубу диаметром 25 мм. Диаметр подстаканника 77 мм. Подходит для бумажных стаканчиков от 300 мл. Я печатал со 100% заполнением, но, как мне кажется, и с 0% заполнением распечатается нормально.
Statistics
Likes
0
Downloads
0