Airlift/Payload Kit for DJI Mini 2, DJI Mini SE, and Mavic Mini
Description
Start your own drone delivery service and deliver cargo/payloads with your DJI Mini 2! Everything is fully 3D printable without supports, you just need some string or a wire. The mount is *designed* to move/shift around quite a bit. This does not matter when flying, however, as long as the mount stays attached to the drone. It cannot be any tighter or else when you try removing the mount from your drone, the bottom cover of your drone may come off and you will need to find a replacement. Disclaimer: This kit, as well as any payloads you may attach, **will** put your drone over 250 grams in weight. If you're flying in the US, please make sure your drone is registered with the FAA before taking off. (It takes less than 10 minutes and only costs $5 USD!) You can register your drone here: https://faadronezone.faa.gov/ The mount was remixed from this part by CyberCyclist: https://www.thingiverse.com/thing:4100532 The landing legs by KugelfanG can also be found here: https://www.thingiverse.com/thing:5139668 however, please keep in mind you will need to use the lay-flat option in Cura for two of the legs. I have already done that for you here. You can also use your own landing legs, just make sure they give enough ground clearance for the undercarriage mount. The grappling hook by MrC500 can be found here: https://www.thingiverse.com/thing:4892363
Statistics
Likes
0
Downloads
0