120mm Jetfan ECO Intake Ring
Description
Inlet ring for the Jetfan 120 ECO EDF For best results, wet sand the inside of the print, then prime/paint, and wet sand again. Repeat until the surface is silky smooth. There is a bit of a ridge on the outer edge of the intake, which allows for some bed adhesion when printed in the orientation shown. It's best to sand the edge out to a smooth finish with the rest of the inlet. This was designed for an open duct system in a Black Horse Viper 120mm, but should work with similar open duct systems so long as there is room in the plane. Secure it to the fan housing with some decent tape.
Statistics
Likes
0
Downloads
0