EleksMaker EleksLaser Draw Module Plate and Sled
Description
I had an old EleksLaser at home and after I repaired and improved it with carriage tensioners (https://www.thingiverse.com/thing:3422982) and a cable chain (https://www.thingiverse.com/thing:2765001) i thought I am going to build a draw module with the stuff I have at home. So I present the probably cheapest version of a draw module for the EleksLaser! ;-) 2x M6x100 shaft screws 1x mounting plate 1x 3 piece sled (the bottom has a smaller bore which fit nice for the M6 thread) 1x 20mm spring (two were too much) 1x Pen holder of your own choice. I used this one: https://www.thingiverse.com/thing:261162 from EGoe 1x Analog Micro Servo (I used an Reely S-0009 MG) LaserGRBL also sends the pen lift signal to the servo output without any further settings. https://lasergrbl.com/ Have fun!
Statistics
Likes
0
Downloads
0