Battery Mockups
Description
This is an AA battery mockup designed to replace AA batteries with an external power source. You will need 2 one-sided PCB pieces. One with a 5 mm diameter and another one with a 9 mm diameter. You will need to print 2 body and attach one PCB piece at the end of each one. The 5 mm PCB piece will act as the negative pole, while the 9 mm one as the positive pole. Some glue is needed to attach the PCB pieces to the end of the battery mockups. You will also need a soldering iron. You will need to solder a wire to each PCB piece. Support material is not required. An infill of 20% is recommended. This object main web page is: http://www.ctheroux.com/battery-mockups/. This object was designed using Solid Edge Community Edition. You can request the source files on the page listed above.
Statistics
Likes
0
Downloads
0