1-1/2" (38mm) Tube Notcher Contour Gauge V2
Description
This is a DIY version similar in function to the Pipe Master Contour Gauge. I tried a few other designs but they did not work/fit correctly, so I made my own. I recommend printing about 45 minutes of the part then stopping the print to check clearances of the tube and your cut pins. Yes it will waste a bit of material but it helps get the settings just where you need them. The pins should have some resistance and not just fall in or out. I am using 3/32 tig rod, cheap and easy. I uploaded the fusion 360 file incase you need to make adjustments yourself. I used cheap Solutech PLA and its worked fine as there is not much to go wrong once you get the fit dialed in. .4 nozzle, 0.16 layer height.
Statistics
Likes
0
Downloads
0