USB hub 8040 ALU rig mount
Description
Remix of Ortovox USB hub holder for alu rigs. The original was a bit too loose for me, making it rattle on a motion rig. Redid this one to make it fight tighter on the ALU extrusion. No ratteling anymore, and rock steady. Also made it so it can be printed with no supports. Just rotate correctly in your slicer. Heads up, it is very tight, so advice printing with 100% infill. Also forgot to rotate one of the nuts, so make sure you rotate it into place the correct direction. (One goes on CW the other CCW.) Made to fit a 16 port i-Tec USB hub. (Specifically this one: https://www.multicom.no/i-tec-usb-30-charging-hub/cat-p/c/p1000039985)
Statistics
Likes
0
Downloads
0