Hario V60 Carafe Protector
Description
A small, simple protector to sit between a V60 and a carafe. To me, putting a ceramic V60 onto a glass carafe seemed like asking for chips. None of the drip stations appeared to cater to a wide-bottomed carafe, or once printed simply did not work with regards to provided instructions and tolerances. My carafe has a top diameter of 70mm, but this was designed with a bit of space in mind so should sit snug on anything up to 80mm. My Hario V60 (no 2) has an OD of 66mm but set the protector to 68 for a little wiggle room and printer tolerances. If you need to make adjustments, the tinker is here: https://www.tinkercad.com/things/fDa03kTZ0cG See it in progress here: https://www.instagram.com/reel/CdhZx5Hq50U/?igshid=YzAyZWRlMzg=
Statistics
Likes
0
Downloads
0