2.5 Hard drive Rack Mount (4x)
Description
This is a rack-mountable hard drive holder. It holds up to four 2.5 inch HD's/SSD's. I labeled this as a remix because the actual part that holds the hard drives is based on the Dell r610 caddy thing, I just smashed 4 of them together, I was too lazy to do the measurements myself. Also, this was designed around the same 2U rack modular system for raspberry pis, see this thing: https://www.thingiverse.com/thing:1793758 So you should be able to mount this in the same modular rack frame if you use the "hdrackmount-2UModularFit.stl" and it will consume 2 spaces wide. The other STL "hdrackmount.stl" does not line up with the holes and is not the correct width as 2 of the raspberry pi mounts and is a little smaller, im using this version for my rack because i do not own the 2U rack modular system and i built my own out of wood :) I printed in the orientation that the STL shows and had to use supports for the bottom (prusa slicer draw on suport is awesome), the reason i did not print it on its face is because my slicer kept trying to print the back part infill first before the perimeter although i had the correct settings that should prevent this.
Statistics
Likes
0
Downloads
0