HMG6 Ender5 Exoslide+MSDD Gantry&Base Combo
Description
This is a Hero Me Gen 6 Gantry+Base Combo specifically for Ender 5 printers using Exoslides with a MicroSwiss Direct Drive bracket. This is inspired from this base that I used with HMG5: https://www.thingiverse.com/thing:4649222 I essentially took the same mounting points and combined it with the HMG6 base and made a few minor adjustments to reduce material. Also, I am using the BLTouch Wing STL found in the same link above. For firmware probe offset I am using { -55, -16, 0}. My z-probe offset is around 3.2 but yours may vary. Note that I am using this front bar relocator bracket (https://www.thingiverse.com/thing:4573655) so you MAY have some interference if you are running a stock frame setup.
Statistics
Likes
0
Downloads
0