Enclosure Filament Guide Hole Cover
Description
This part is intended to be used outside of a printer enclosure to cover up the hole for the filament insertion. At the same time it can act as point of attachment for the filament tube. It has a 5,5 mm diameter hole on one side. A PC-4 M6 push fitting can be attached to connect to PTFE tube. Please note that you will most likely need a wrench or pliers to screw the push fitting in. The part can be held in place by using two small screws and making use of the 3 mm holes on the outer side.
Statistics
Likes
0
Downloads
0